New! Linear Volt. Regulators

RXB15003 - Li-Poly Receiver Battery

The RXB Series LiPo packs have a much higher gravimetric power density than any other current, non-experimental chemistry.  In other words, excellent power-to-weight ratio, as compared with nickel chemistries. The RXB also have a higher cell voltage, and a relatively flat discharge curve.  This means that power to the servos is more consistent (since it must go through a step-down regulator). It also means slightly elevated voltages to the servos is feasible, which also makes a noticeable difference in performance. Also RXB Receiver battery packs have a built in cell balancer which will protect and balance cells when charging. This will also prolong the life of your battery pack.  The battery can be charged while in the model as long as a Li-Poly charger is used.

Voltage: 7.4V DC Capacity: 1500mAh Cell Count: 2 Charge Amp(max): 1C Discharge Amp: 3A Dimensions: 65 x 35 x 14mm (length x width x high) Weight: 64g

Click to enlarge

Volt. Regulator 3A

The VR-3 is a switch-mode DC regulator separated from ESC, it will take high-voltage (5.5V-23V) power from your battery pack and convert it to a consistent safe voltage for your receiver, gyro and servos.
Input: 5.5V-23V (2-5s lithium battery pack, 5-15cells NiMh / NiCd battery pack) Output: 5V/3A or 6V/3A(50% Duty), MAX. 5A(10% Duty) Dimensions: 43 x 19 x 8mm (length x width x high) Weight: 8g(cables included)	Click to enlarge

Transmitter batteries

Time to upgrade!  For many years 9.6V Ni-Cd  battery packs have been used in RC transmitters, but Dualksy has brought the radio world into the high power of Li-Poly batteries.    We have developed a new Li poly battery packs to replace the old tired Ni-Cd packs.  These new packs provide 3 times the duration at half the weight!   Now you can charge your radio once a month, instead of once a week!   Also our transmitter Li-Poly battery packs have a built in cell balancer which will protect and balance cells when charging.  This will also prolong the life of your battery pack.  The battery can be charged while in the radio as long as a Li-Poly charger is used.   No modifications are required, just install the pack into your radio with the Fuatabaplug and fly!  All transmitters are programmed to sound a Low Battery alarm and this will allow safe time land the plane and charge your battery.   We also can supply connectors for JR or other brand transmitters.

TXB25003-JR new! - For JR transmitters TXB25003-FU - For Futaba transmitters Output: 11.1V, 2500mAh (Super Power Density) Dimensions: 95 x 30 x 25mm (L x W x H) Weight: 150g

Click to enlarge